Alarmmate GSM Alarm System Manual de usuario descargar pdf (Pagina 14)

A Top Safety and Protection Solution Worldwide!

Page １３ of 32 Ver 1.0

Auto-Dial Tel. Numbers for 3 times one by one, and Send SMS to the Pre-set SMS Alert

Numbers. In the meantime it will drive the siren for 60seconds and close the link-Output

relay for 4 minutes.

2) After you enter the menu, the attribute of the zone will be displayed in the

LCD, if this zone has been assigned a wireless sensor, it will display “V”. If it

hasn’t been assigned a wireless sensor, it means this zone is empty, you

can assign a new wireless sensor to this zone. Press the Up or down button

on the keyboard to check the other Zones. Press Enter to edit it. After you

pressed the Enter button, you can select the zone attribute, and then press

Enter again, you will see “Turn on the device” or “Please trigger the new

wireless sensor”. Then follow the instructions to add the new wireless

sensor to the device. The Remote control will display VVVV if the unit has

been assigned. You can press Enter to re-assign new wireless sensors or

remote controls to replace the existence ones.

3) In the Edit RF Parts you can edit the attribute of the sensor as Normal or

Stay type. If the system is on Stay Mode (Also At House or Partial Armed),

the sensor set as Normal triggered, will not alarm, the sensor set as Stay

triggered, will alarm. If the system is under Armed Mode, then all RF sensors

triggered, will alarm. It is very important to remember the sensor types of the

system. This function is very useful when you are at home and need some

sensors in working status (E.g.: the sensor installed outer and gas and

smoke detectors, etc.) and some sensors indoor not in working status (e.g.:

the sensors installed in the living room, bed room, etc.).

4) The unit can accept a total of 16 wireless sensors to 16 wireless zones; each

zone can be assigned one wireless sensor, and renamed by SMS Command.

And 5 remote controls.

5) Wireless Zone Serial Number, Default Zone Name and Zone Attributes

Table.

Zone SN.

Default Zone Name

Default Zone Attribute

Intrusion from Entry Door

Normal

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sin comentarios

Alarmmate GSM Alarm System Manual de usuario Pagina 14