Alarmmate GSM Alarm System Manual de usuario Pagina 28

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 27
A Top Safety and Protection Solution Worldwide!
Page 27 of 32 Ver 1.0
Notice:
1. Some wireless sensors must be coded by manual as below 9.1 step; some
wireless sensors don’t need manual coding, because it will use the learning
code sensor. Follow step 9.1 for learning the code wireless sensor, it is the
same as the PIR-100B and DM-100A.
2. Please remember to setup the PIR-100B to Test Mode while programming
the host. After it is assigned to the mainframe, then please setup USER
Mode by changing the Black PIN Jumpers in the PIR-100B, please see the
PIR-100B user manual.
The Wireless sensors in the package box are pre-coded prior to shipping.
The max quantity of RF sensors is 16, if you need to add more then you can
set the wireless sensor with the same jumper. Add additional wireless
sensors to the control units, please see below:
9.1 Prepare the RF Sensors of PT2262 IC Code
1) Prepare the RF sensors, Open the back cover of the Wireless sensor
carefully;
2) Locate the IC boards black jumpers, labeled A0-A7 and D0-D3.
3) Configure the A0~A7 and D0~D3 different from each wireless sensor
(Includes wireless door sensor, wireless smoke sensor, wireless gas
leakage sensor, wireless pir motion sensor etc). If configured the A0~A7
and D0~D3 are the same, the system will treat them as the same sensor.
4) Please check that the resistors value is 3.3M Ohm, there are 3 Jumpers,
1.5M, 3.3M and 4.7M. If you select the incorrect value, the wireless
distance will be very short or can not learn to the alarm panel.
9.2 Enter the RF Sensor Adding Menu.(See 6.2.2.1 Add/Del RF Parts)
Vista de pagina 27
1 2 ... 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios