Alarmmate GSM Alarm System Manual de usuario descargar pdf (Pagina 19)

A Top Safety and Protection Solution Worldwide!

Page １８ of 32 Ver 1.0

Notice:

1) The watchdog is specifically designed for the elderly, children or on-duty

personnel. In the period (Starting time point to Ending time point) if this sensor

hasn’t been triggered, the system will alarm. This is very useful to monitor the

person going out the bedroom or entering another room. Or monitor the

on-duty personnel while on duty.

2) If you enable the RCO alert function, use any remote control which has been

registered to the system to arm, disarm or stay operation. The system will

send an SMS to the first SMS number.

3) If you enable the GSM Jammer Alert function, when the GSM Signal is 0 for

more than 90seconds, the system will drive the siren for 60seconds and the

link-output relay will close for 4 minutes.

6.3 Modify the SMS Alert Content of the Zone (Zone or Sensor Name)

The unit accepts SMS Command to modify the SMS Alert Content of the

zone.

For Wireless Zone Name, the format is: Password+#+M+Zone Serial

Number+#+New Zone Name+#. Characters for the zone name are 32. The

Zone Serial Number is 01~16 corresponding to the LCD Menu and 6.2.2.1

1.Edit Timer

2. Watchdog Timer

3. RCO Alert

4. GSM Jammer Alert

5. Modify Password

6. Default Set

---To setup the starting time to arm and the Ending

time to disarm.

---To setup the starting and ending time to work.

---To setup the remote control operation report

function.

---To setup the GSM Jammer Alert function.

---Modify the system password.

--- Restore the system settings to factory defaults.

All of the remote controls and wireless sensors

should be re-assigned again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Sin comentarios

Alarmmate GSM Alarm System Manual de usuario Pagina 19